Dahua Technology XVR4 Series - Page 124

Local Configurations 111
Figure 5-79
Configure the settings for the manual adding device parameters. See Table 5-30. Step 2
Parameter
Description
Channel
In the Channel list, select the channel that you want use on the
Device to connect the remote device.
Manufacturer
In the Manufacturer list, select the manufacturer of the remote
device.
IP Address
In the IP Address box, enter the IP address of remote device.
The default is 192.168.0.0 which the system cannot connect to.
RTSP Port
The default value setting is 554. You can enter the value according to
your actual situation.
HTTP Port
The default value setting is 80. You can enter the value according to
your actual situation.
If you enter other value, for example, 70, and then you should enter
70 after the IP address when logging in the Device by browser.
User Name
Enter the user name of the remote device.
Password
Enter the password of the user for the remote device.
Remote Channel
Enter the remote channel number of the remote device that you want
to add.
Decoder Buffer
In the Decoder Buffer list, select Default, Realtime, or Fluent.
Protocol Type
If the remote device is added through private protocol, the default

type is TCP.
If the remote device is added through Onvif protocol, the system
