Local Configurations 208
Figure 5-179
Configure the parameters settings. See Table 5-53. Step 2
Indicates the channel that the camera is connected to.
In the Display Type list, select List or Graph.
Select the information type that you want to search. You can select
Humidity or Temperature.
Select the information state that you want to search.
This option is available when you select List in the Display Type
list.
Enter the start time and end time for the information that you want
to search.
Table 5-53
Click Search. Step 3
The system starts search according to your parameters settings. After searching is
finished, the result displays.
For the data displayed in list, see Figure 5-180.
Click Go To to switch result pages.
To Next Page
Loading...
