Local Configurations 265
Figure 5-243
Configure the parameters. For details, see Table 5-74. Step 2
Enable or disable the password reset function. It is enabled
by default.
If the password reset function is disabled, you can find back
the password by the security questions. Make sure you have
configured the security questions.
If you enable this function, the snapshots that are activated
by the alarm event on the Device can be sent to mobile
phone.
This function is enabled by default.
If this function is enabled, the remote devices can be added
through the CGI protocol.
This function is enabled by default.
If this function is enabled, the remote devices can be added
through the ONVIF protocol.
This function is enabled by default.
Enable or disable the audio and video stream encryption. If
enabled, make sure the devices or software support
decryption.
Table 5-74