Local Configurations 55
The interface requiring device initialization is displayed. A pop-up message
reminding you to make sure the Device is initialized is displayed.
Tap OK. 3)
 If the Device has not been initialized, Tap Device Initialization to perform
initializing by following the onscreen instructions.
 If the Device has been initialized, you can start adding it directly.
Tap Add Device. 4)
The Add Device interface is displayed. See Figure 5-21.
You can add wireless device or wired device. The Manual takes adding wired
device as an example.
Figure 5-21
Tap P2P. 5)
The P2P interface is displayed. See Figure 5-22.
To Next Page
Loading...
Need help?
General
