120
register function, the device can auto register to the proxy server.
1) The setup interface is shown as in Figure 4-98.
Important
Do not input network default port such as TCP port number.
Figure 4-98
2) The proxy server software developed from the SDK. Please open the software and input the global
setup. Please make sure the auto connection port here is the same as the port you set in the previous
step.
3) Now you can add device. Please do not input default port number such as the TCP port in the mapping
port number. The device ID here shall be the same with the ID you input in Figure 4-98. Click Add button
to complete the setup.
4) Now you can boot up the proxy server. When you see the network status is Y, it means your
registration is OK. You can view the proxy server when the device is online.
Important
The server IP address can also be domain. But you need to register a domain name before you run proxy
device server.
4.8.1.6 P2P
You can use your cell phone to scan the QR code and add it to the cell phone client. For detailed
operations, see chapter 4.1.4.3 P2P.
Via the SN from scanning the QR code, you can access the device in the WAN. Please refer to the P2P
To Next Page
Loading...
Need help?
General