171
Figure 5-28
Step 2 File backup encryption is enabled by default. Click OK to select the save path.
Step 3 Click Save. After the export is completed, system pops up a dialogue box to show that backup is
completed.
Note
Backup encryption is enabled by default when exporting IP. The file contains information such as IP
address, port, remote channel number, manufacturer, username and password.
If file backup encryption is enabled, the extension name of the exported file is .backup. Except the
NVR device, any other software cannot open and edit the file.
If the backup encryption is disabled, the extension name of the exported file is .csv. It might lead to
data leakage.
Import IP
You can import the added device list to add the device conveniently.
Click Import button, and then select the import file.
Note
If the imported IP is already in the added device list, system pops up dialogue box for you to confirm
overwrite or not.
Click OK button, the new IP setup can overwrite the old one.
Click Cancel button, system adds the new IP setup.
Important
You can edit the exported file. Please make sure the file format is the same. Otherwise you cannot
import the file again!
System does not support customized protocol import/export.
The import/export function is for the devices of the same language.
5.10.1.1.2 IPC Upgrade
This interface is to upgrade network camera.
From Main menu->Setting->Camera->Registration->IPC upgrade, enter the following interface. See
Figure 5-29.
Click Browse button to select upgrade file. Or you can use filter to select several network cameras at the
To Next Page
Loading...
Need help?
General