192
System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.
System can delay the alarm output for specified time after an
alarm ended. The value ranges from 1s to 300s.
System can pop up a message to alarm you in the local host
screen if you enabled this function.
You need to click setup button to select tour channel. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs. See Figure
5-58.
Here you can set PTZ movement when alarm occurs. Such as go
to preset X. See Figure 5-57.
Click setup button to select snapshot channel. See Figure 5-59.
5.10.3.1.1 Video Loss
The video loss interface is shown as in Figure 5-60.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest setups, please refer
to chapter 5.10.3.1.1 motion detect for detailed information.
Figure 5-60
5.10.3.1.2 Tampering
The tampering interface is shown as in Figure 5-61.
After analysis video, system can generate a tampering alarm when the detected moving signal reached
the sensitivity you set here.
For detailed setups, please refer to chapter 5.10.3.1.1 motion detect for detailed information.
To Next Page
Loading...
Need help?
General