Dahua NVR41 series User Manual

User's Manual
110
Parameter
Description
DHCP
Enable the DHCP function. The IP address, subnet mask and
default gateway are not available for configuration once DHCP
is enabled.
● If DHCP is effective, the obtained information will display in
the
IP Address
box,
Subnet Mask
box and
Default
Gateway
box. If not, all values show 0.0.0.0.
● If you want manually configure the IP information, disable
the DHCP function first.
● If PPPoE connection is successful, the IP address, subnet
mask, default gateway, and DHCP are not available for
configuration.
IP Address
Enter the IP address and configure the corresponding subnet
mask and default gateway.
IP address and default gateway must be in the same network
segment.
Subnet Mask
Default Gateway
DNS DHCP
Enable the DHCP function to get the DNS address from router.
Preferred DNS
In the
Preferred DNS
box, enter the IP address of DNS.
Alternate DNS
In the
Alternate DNS
box, enter the IP address of alternate
DNS.
MTU
In the
MTU
box, enter a value for network card. The value
ranges from 1280 byte through 1500 byte. The default value is
1500.
Test
Click
Test
to test if the entered IP address and gateway are
interworking.
Step 4 Click
OK
to go to NIC settings.
Device goes back to
TCP/IP
interface.
Step 5 Set network parameters. See Table 4-6.
Table 4-6
Parameter
Description
IP Version
There are two options: IPv4 and IPv6. Right now, system
supports these two IP address format and you can access
via them.
Preferred DNS server
DNS server IP address.
Alternate DNS server
DNS server alternate address.
MAC Address
Displays the MAC address of the Device.

Dahua NVR41 series Specifications

General

Brand	Dahua
Model	NVR41 series
Category	Network Hardware
Language	English