21
5.1.1.3 LAN Config
Configure VTO building no., unit no. and VTO no. info.
Select “System Config> LAN Config”. Step 1
The system displays “LAN Config” interface, as shown in Figure 5-6.
Figure 5-6
Enter VTO “Building No.”, “Building Unit No.” and “VTO No.”. Step 2
To call the management centre, please tick “Register to the MGT Centre”, and set
“MGT Centre IP Address” and “MGT Port No.”. Enable or disable “No Answer
Transfer MGT Centre”.
To provide group call function, please tick “Group Call” and set “Max Extension
Index”, which is 5 at most.
Click “OK”. Step 3
5.1.1.4 Add VTH
Add VTH info. After VTH and VTO have completed debugging, VTH will be registered on VTO
automatically and realize bonding.
Add master VTH.
After “Network” interface of extension VTH has added and enabled master VTH, VTO
interface will obtain extension VTH info automatically.
Select “System Config> Digital Indoor Station Manager”. Step 1
The system displays “Digital Indoor Station Manager” interface, as shown in Figure 5-7.
To Next Page
Loading...
