In Figure 4-22, input tour value and then click to call a tour. Click again
to stop call.
Call Scan
In Figure 4-22, input Scan value and then click to call a tour. Click again
to stop call.
Rotate
In Figure 4-22, click to enable the camera to rotate.
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:
Preset, tour and pattern all need the value to be the control parameters. You can
define it as you require.
You need to refer to your camera user’s manual for Aux definition. In some cases, it
can be used for special process.
Aux
Click , system goes to the following interface. The options here are defined by the
protocol. The aux number is corresponding to the aux on-off button of the decoder. See
Figure 4-28.
Figure 4-28
4.5.4 Auto Focus
It is to set auto focus function. Please make sure the camera supports this function.
4.5.5 Color
Here you can set hue, brightness, contrast, saturation, gain, white level, color mode
and etc. See Figure 4-29.
To Next Page
Loading...
