Figure 4-112
Motion detect here only has relationship with the sensitivity and region setup. It has no
relationship with other setups.
4.11.3.1.2 Video Loss
In Figure 4-108, select video loss from the type list. You can see the interface is shown
as in Figure 4-113.This function allows you to be informed when video loss
phenomenon occurred. You can enable alarm output channel and then enable show
message function.
Tips:
You can enable preset/tour/pattern activation operation when video loss occurs.
Please refer to chapter 4.11.3.1.1 motion detection for detailed information.
To Next Page
Loading...
