Figure 5-81
Please refer to the following sheet for detailed information.
The abnormal events include: No disk, disk error, disk no space, net
disconnection, IP conflict and MAC conflict.
You can set one or more items here.
Less than: You can set the minimum percentage value here (For disk
not space only). The device can alarm when capacity is not sufficient.
You need to draw a circle to enable this function.
Check the box here to enable selected function.
Please select corresponding alarm output channel when an alarm
occurs. You need to check the box to enable this function.
The alarm output can delay for the specified time after an alarm stops. The
value ranges from 0s to 300s. The default setup is 10 seconds. The o
second means there is no delaying time.
It is to set login attempt times. Once the login attempt exceeds the
threshold you set here, current account will be locked. This function is for
illegal login only.
It is to set account lock time once its login attempt has exceeded the
threshold you set. This function is for illegal login only.
System can pop up a message to alarm you in the local host screen if
you enabled this function.
System can upload the alarm signal to the center (Including alarm
center.
To Next Page
Loading...
Need help?
General