Daikin VRV K - 1.2 Failure Diagnosis

Test Operation Si-95
66 Test Operation Inverter K Series
Operation Contents
and Function
If you set a Master remote controller
(Remote controller not displaying
<CHANGEOVER UNDER CONTROL>)
The other remote controllers
(Remote controllers displaying
<CHANGEOVER UNDER CONTROL>)
1.
Set to Cool/Heat/Auto
● switch to the operation mode set
by the master remote controller.
● However, they can switch to FAN
operation and from COOL to
DRY.
If you set a Master remote controller
(Remote controller not displaying
<CHANGEOVER UNDER CONTROL>)
The other remote controllers
(Remote controllers displaying
<CHANGEOVER UNDER CONTROL>)
2.
Set to FAN,
● cannot set any mode other than
FAN.
(VL049)
SI-95.BOOK Page 66 Friday, March 31, 2000 10:59 AM