Si-95 Test Operation
Test Operation Inverter K Series 71
1.15 Remote Controller Service Mode
How to Enter the
Service Mode
Service Mode
Operation Method
1. Select the mode No.
Set the desired mode No. with the button.
(Forced FAN ON “43” only can be set by wireless remote controller.)
2. Select the unit No. (For group control only)
Select the indoor unit No. to be set with the time mode
(Selected the unit No. with button for wireless remote controller)
3. Make the settings required for each mode. (Modes 41, 44, 45)
Before setting, press button and make condition to change setting.
(“Code” will flush on L. C. Display.)
For details, refer to the table next page.
4. Define the setting contents. (Modes 44, 45)
Define by pushing the timer button.
(After defining, “Code” will change from flushing to ON.)
5. Return to the normal operation mode.
Push the button one time.
SI-95.BOOK Page 71 Friday, March 31, 2000 10:59 AM
To Next Page
Loading...
