The “Fix RAID” button (see picture below) only appears when my-
Ditto detects that RAID is not functioning well. Click the Fix RAID
button; the system will now try to recover. When the fix operation is
over, turn Off my-Ditto and then On again. The RAID mode is back to
normal.
Note: If one of the hard disk drives LED (HDD1/HDD2) is blinking
(the hard disk is damaged), turn Off my-Ditto, replace the hard disk
with a new one (of the same size as the previous one) and turn it On
again.
Note: When in RAID 0, if one of the hard disks fails, it is impossible to
fix the RAID, resulting in the loss of data previously stored on the
damaged disk.
Note: When entering RAID/JBOD mode it will take several minutes for the disks to be activated.
A completion status indication appears in the Storage Status tab.
To Next Page
Loading...
Need help?
General
