FC 300 CANopen
- I n t r o d u c t i o n -
6 MG.33.J1.02 VER. 050301 – VLT is a registered Danfoss trademark
Topology
Assumptions
These operating instructions assume that you are using a Danfoss FC 300 frequency converter with
CANopen. It is also assumed that as master you are using a PLC or PC equipped with a serial
communication card supporting all the CANopen communication services required by your application.
Furthermore, it is assumed that all requirements stipulated in the CANopen standard as well as those set up
in the AC Drive Profile and those pertaining to the VLT frequency converter are strictly observed as well as
all limitations therein fully respected.
Hardware
These operating instructions relate to the CANopen option type nos. 130B1103
Background Knowledge
The Danfoss CANopen option is designed to communicate with any master abiding by the CANopen
standard. It is therefore assumed that you have full knowledge of the PC or PLC you intend to use as a
master in your system. Any questions pertaining to hardware or software produced by any other
manufacturer is beyond the scope of these operating instructions and is of no concern to Danfoss. If you
have questions about how to set up master - master communication or communication to a non-Danfoss
slave, please consult the appropriate documentation.
FC 300-related Literature
The following literature is available for the FC 300 series.
Title Literature no.
FC 300 Operating Instructions MG.33.AX.YY
FC 300 Design Guide MG.33.BX.YY
FC 300 Profibus Operating Instructions MG.33.CX.YY
FC 300 CANopen Operating Instructions MG.33.DX.YY
FC 300 CANopen Operating Instructions MG.33.JX.YY
FC 300 MCT 10 Software Dialogue MG.33.EX.YY
Profibus DP V1 Design Guide MG.90.EX.YY
Please also refer to http://www.danfoss.com/drives for frequently asked questions and additional
information.
Abbreviations
To Next Page
Loading...
Need help?
General
