Chapter 1.0 Introduction
This Applications and Installation Manual is intended to be a guide for application data/installation procedures
specific to Danfoss Turbocor compressors. It is not intended to inform on fundamental safety, refrigeration and
electrical design skills. It is assumed and presumed that persons using this manual are appropriately certified and
have detailed knowledge, experience and skills in respect to designing for and working with high pressure
refrigerants and medium voltage electrical components (to 1 KV high power AC & DC) as well as complex control
systems.
Some potential safety situations may not be foreseen or covered in this guide. Danfoss LLC assumes personnel using
this manual and working on Danfoss LLC compressors are familiar with, and carry out, all safe work practices
necessary to ensure safety for personnel and equipment.
1.1 Scope
This manual is designed for use with Bearing Motor Compressor Controller (BMCC) software, Version 4.0.0 and later.
Table 1-1 Application Manual Applicability
Manual Release Date BMCCFirmware Versions
M-AP-001-XX Rev E September 2013 CC 2.3.1213
M-AP-001-XX Rev L October 2016 CC 3.1.4
M-AP-001-XX Rev M November 2017 CC 4.0 and later
M-AP-001-XX Rev M.1 November 2017 CC 4.1 and later
M-AP-001-XX Rev N May 2018 CC 4.1 and later
M-AP-001-XX Rev P.1 November 2019 CC 4.2 and later
M-AP-001-XX Rev R January 2021 CC 4.3 and later
1.2 Document Symbols
The following symbols are used in this document.
NOTE: Provides additional information such as a tip, comment, or other useful, but not imperative information. A
Note is displayed in the format shown below.
NOTE
M-AP-001-EN Rev. S-9/8/2021 Page 11 of 136
To Next Page
Loading...
Need help?
General
