Chapter 18.0 Environmental Considerations
18.1 Humidity
If the compressor is installed in a humid environment, drip trays may be required to collect condensate. Insulation
should be installed on the suction valve/piping and the end cap as this is where condensation is most likely to form.
It is recommended to fit an End Cap insulator in a humid environment.
NOTE
The End Cap insulator is not available for TGH/TTH compressors.
18.2 Vibration
External copper piping should be braced to minimize the transfer of vibration to the compressor.
M-AP-001-EN Rev. S-9/8/2021 Page 111 of 136
To Next Page
Loading...
Need help?
General
