start
Follow the instructions in Chapter 3 to install the inverter and wire it
Make sure the power cable , motor cable and brake unit are connected
correctly
Observe the safety precautions and switch on the power supply
Enter guide mode -GdE-
Set each parameter in turn according to the
guidance of the wizard , set the motor self -
learning mode P 11.10, press the run b utton,
waiting for the complete of self -learning
• Press RUNto Run inverter
• Press STOP to stop inverter
While monitoring the output frequency
or command frequency ,press
ENTERto modify the target
frequency
End
close loop vector control (VC),Before normal
operation , ensure that the encoder P 10.03 is in
the correct directionIf rotary self -learning is
performed , the encoder orientation can be
automatically recognized and storedIf it is not
executed , it needs to open the loop control to
run the motor and observe whether the encoder
feedback (r10.12) is in the same direction with
the given direction , if no,change as P 10.03
Open control
Y
N
To Next Page
Loading...
