Danfoss VLT 5000 FLUX User Manual

VLT
®
5000 FLUX
value to be changed will flash. To accept the new
setting,press[OK],toabort,press[CANCEL].
■ Initialisation to factory setting
The frequency converter can be initialised to
factory settings in two ways.
I
nitialisation by parameter 620
- Recommended initialisation
• Select parameter 620
• Press [CHANGE]
• Select "Initialisation"
• Press the [OK] key
• Cut off the mains supply and wait until
the display turns off.
• Reconnect the mains supply - the frequency
converter is now reset.
This parameter initialises all except:
500 Serial communication address
501 Baud rate for serial communication
601-605 Operating data
615-617 Fault logs
Manual initialisation
• Disconnect from mains and wait until the
display turns off.
• Press the following keys at the same time:
[Display/status]
[Change data]
[OK]
• Reconnecting the mains supply while
pressing the keys.
• Release the keys
• The frequency converter has now been
programmed for the fact
ory setting.
This parameter initialises all except:
600-605 Operating data
NB!:
Settings for serial communication and
fault logs are reset.
MG.55.A6.02 - VLT is a registered Danfoss trademark
50

Danfoss VLT 5000 FLUX Specifications

General

Brand	Danfoss
Model	VLT 5000 FLUX
Category	DC Drives
Language	English