Product Reference Guide 119
Chapter 7
Software Configuration
Software configuration of your Matrix 120 for static reading or simple code
reading applications can be accomplished by the Rapid Configuration procedure
using the X-PRESS HMI (which requires no external configuration program). This
procedure is described in
Chapter 1, Steps 3-4.
For the majority of applications however you will use DL.CODE, connecting to the
reader through the on-board Ethernet interface. See
Chapter 1, Steps 5-6.
DL.CODE System Requirements
To install and run DL.CODE you should have a Laptop or PC that meets or
exceeds the following:
• 2.00 GHz or faster microprocessor
• Windows: XP SP3, 7, 8, or 10
•1 GB RAM
• 2 GB hard disk for 64-bit machines; 1 GB hard disk for 32-bit machines
•100 Base-T Ethernet
• One 19" or larger monitor (optimized for 1280x1024 resolution)
CAUTION
DL.CODE does not currently support Windows Embedded (often used in industrial PCs
and/or PLCs).
To Next Page
Loading...
