viii
Matrix 120
Compliance
General
For installation, use and maintenance it is not necessary to open the reader.
Only connect Ethernet and dataport connections to a network which has routing
only within the plant or building and no routing outside the plant or building
Power Supply
ATTENTION: READ THIS INFORMATION BEFORE INSTALLING THE PRODUCT
This product is intended to be installed by Qualified Personnel only.
This product is intended to be connected to a UL Listed Computer (LPS or “Class
2”) which supplies power directly to the reader, or a UL Listed Direct Plug-in
Power Unit marked LPS or “Class 2”.
EMC Compliance
In order to meet the EMC requirements:
• connect reader chassis to the plant earth ground by means of a flat copper
braid shorter than 100
mm;
• connect pin "Earth" of the CBX connection box to a good Earth Ground.
CE Compliance
CE marking states the compliance of the product with essential requirements
listed in the applicable European directive. Since the directives and applicable
standards are subject to continuous updates, and since Datalogic promptly
adopts these updates, therefore the EU declaration of conformity is a living doc
-
ument. The EU declaration of conformity is available for competent authorities
and customers through Datalogic commercial reference contacts. Since April
20th, 2016 the main European directives applicable to Datalogic products
require inclusion of an adequate analysis and assessment of the risk(s). This
evaluation was carried out in relation to the applicable points of the standards
listed in the Declaration of Conformity. Datalogic products are mainly designed
for integration purposes into more complex systems. For this reason it is under
the responsibility of the system integrator to do a new risk assessment regarding
the final installation.
To Next Page
Loading...
