Backup and Restore Through DL.CODE
Product Reference Guide 143
Restore
To perform a Restore:
1. From the DL.CODE Device menu, select Single Reader Restore (from file on
PC).
At the end of the restore, DL.CODE shows a message indicating successful
completion.
Replacement
The Restore function also provides easy and secure Single Device Replacement:
1. Remove the device to be replaced.
2. Connect the new device (make sure the new device has been previously set
to factory default).
3. Run the Restore procedure by selecting either Single Reader Restore (from
file on PC) (see: Restore procedure).
CAUTION
The replacement device must be the exact same model as the device it is replacing.
NOTE
In case of Backup or Restore operation failures, error messages will be displayed in
the Monitor Diagnostic page.
To Next Page
Loading...
