Step 6 - Test Mode
Product Reference Guide 29
Step 6 - Test Mode
Use a code suitable to your application to test the reading performance of the
system.
1. Enter the
Test
function by pressing and holding the X-PRESS push button
until the Test LED is on.
2. Release the button to enter the
Test
function.
Once entered, the Bar Graph on the five LEDs is activated and if the reader
starts reading codes, the Bar-Graph shows the Good Read Rate.
3. To exit the Test, press the X-PRESS push button once.
The Bar Graph has the following meaning:
In case of No Read condition, only the STATUS LED (red) is on and blinks.
Figure 13 - X-PRESS Interface: Test Function
NOTE
By default, the Test exits automatically after three minutes.
Figure 14 - Test Function Bar Graph
To Next Page
Loading...
