Datalogic Matrix 120 - On-Board Ethernet Interface; User Interface - Serial Host

On-Board Ethernet Interface
Product Reference Guide 67
On-Board Ethernet Interface
For Ethernet models, the on-board Ethernet Interface can be used for TCP/IP
communication with a remote or local host computer by connecting the reader to
either a LAN or directly to a host PC. There is no need to use a crossover adapter
since Matrix 120 incorporates an auto-cross function.
A CAB-ETH-M0x cable can be used to connect to a LAN.
On the Matrix 120 on-board Ethernet interface the following communication
channels are available:
• TCP Client
•TCP Server
•UDP Channel
•FTP Client
The following Fieldbus protocols are also available over the on-board Ethernet
interface:
• EtherNet/IP
• PROFINET IO
• Modbus TCP Client
For further details refer to the Help On Line page of the Reading Phase step
(Channels) and (Fieldbuses) in DL.CODE.
User Interface - Serial Host
The following table contains the pinout for standard RS232 PC Host interface.
For other user interface types please refer to their own manual.
RS232 PC-side Connections
9-pin male connector 25-pin male connector
Pin Name Pin Name
2 RX 3 RX
3 TX 2 TX
5 GND 7 GND