Datalogic Matrix 120 - Step 4 - Installing DL.CODE Configuration Program

Step 4 - Installing DL.CODE Configuration Program
Product Reference Guide 9
Step 4 - Installing DL.CODE Configuration Program
DL.CODE is a Datalogic reader configuration tool providing several important
advantages:
• Intuitive Graphical User Interface for rapid configuration
• Defined configuration directly stored in the reader
• Discovery and IP address setting features to facilitate remote configuration
• Device Monitoring
• Device Driver Installation
To install DL.CODE:
1. On the PC that will be used for configuration (running Windows XP SP3, 7, 8, or
10), download the DL.CODE mini-DVD.zip file. Extract the files maintaining
the folder structure and run the start.hta file to access the installation pop-up.
Click on the Install DL.CODE link to run the installation program and follow the
installation procedure.
2. When the installation is complete the DL.CODE entry is created in the
Start>Programs bar under “Datalogic” as well as a desktop icon. Double-
click the desktop icon to run it.
Depending on your Matrix 120 model, you can connect to DL.CODE
configuration environment through one of the following interfaces:
CAUTION
DL.CODE does not currently support Windows Embedded (often used in industrial PCs
and/or PLCs).
NOTE
To configure Serial + USB model devices, check the appropriate Matrix USB Driver
and/or RS232 Serial Port Driver installation boxes in the Welcome window of the
DL.CODE Installer. In this case it is recommended to reboot the PC after DL.CODE
installation.
NOTE
To perform a “silent” installation (without user input), see the DL.CODE User’s Guide.
Model Interface Instructions
Matrix 120 xxx-x1x Ethernet Configuration STEP 4A
Matrix 120 xxx-x0x USB Configuration STEP 4B
All
Serial Configuration
a
a. All devices can be configured through their Main Serial port. However,
through this interface, configuration is slower than the Ethernet or USB
interfaces and presents some limitations. It is recommended to use the
Serial interface for configuration only if the other interfaces are not avail
-
able.
STEP 4C