Typical Layouts
70
Matrix 120
Serial Connection
In this layout the data is transmitted to the Host on the main serial interface. The
Ethernet interface can be used for reader configuration by connecting a laptop
computer running DL.CODE.
Data can be transmitted on the RS232 auxiliary interface independently from the
main interface selection to monitor data.
When One Shot or Phase Mode operating mode is used, the reader can be acti-
vated by an External Trigger (for example a pulse from a photoelectric sensor)
when the object enters its reading zone.
Figure 52 - Serial Interface Point-to-Point Layout
All devices always support multiple output channels (i.e. for data monitoring).
Host
CAB-1011
Matrix 120
CBX
Main Serial Interface (RS232 or RS422 Full-Duplex)
Optional outputs
External Trigger (for One Shot or Phase Mode)
10-30 Vdc
External Power for Matrix 120
and I/O Accessories
To Next Page
Loading...
