Step 5 - Device Configuration
Product Reference Guide 27
To create a logical AND condition from a logical XOR, create a new Expected
Code box using the Add icon
. Then drag the desired code icon from one box to
the other.
Data Formatting
1. Configure your application specific Data Formatting Message(s) from the
Configuration Parameters tree area: Message 1, Message 2, etc.
You can add fields to the output message by clicking on the icons above the
Message Field area. They will be appended to the message. You can drag them to
position them between other fields in the message so that the output message is
ordered according to your application requirements.
Each field has its own relative configuration parameters in the parameters panel.
To Next Page
Loading...
