OCR Programming
8-16 PowerScan
®
7000 2D
4.) when the modulo 11 check character “0123456789X” is pro-
grammed.
Please note that all these commands can be combined into a single serial
programming command:
OCRENA2,TMP”ISBNggggggggggggctCdddd hdddEtCdddd
hddddE”,GPG”0123456789-”,GPH”P\”,CHK”0123456789X”.
These commands can be encoded into the following Aztec Code symbol:
OCR Template Codes
† One or more two-digit numbers and Save are required after reading this programming
symbol. Refer to the
Programming Chart on page B-5 of this manual.
NOTE
Reading more than three rows of OCR is not
recommended. Contact the factory if you have
an application that requires reading four or
more rows of OCR.
Enter OCR Template †
Enter User-Defined
Variable “h”†
Enter User-Defined
Variable “g”†
To Next Page
Loading...
