Datalogic PowerScan 7000 2D Product Reference Guide

Print Weight
Product Reference Guide 3-23
Print Weight
Print Weight is used to adjust the way the imager reads Matrix symbols.
If a imager will be seeing consistently heavily printed matrix symbols,
then a print weight of 6 may improve the reading performance. For con-
sistently light printing, a print weight of 2 may help. After scanning the
Set Print Weight bar code, set the print weight (from 1-7) by scanning
digits from the
Programming Chart on page B-5, then scanning Save.
Default = 4.
Video Reverse
Video Reverse is used to allow the imager to read bar codes that are
inverted. The “Off” bar code below is an example of this type of bar
code. If additional menuing is required, Video Reverse must be disabled
to read the menu bar codes and then re-enabled after menuing is com-
pleted.
NOTE
Images downloaded from the unit will not be
reversed. This is a setting for decoding only.
Set Print Weight
* Default
On
* Off

Datalogic PowerScan 7000 2D Specifications

General

Brand	Datalogic
Model	PowerScan 7000 2D
Category	Barcode Reader
Language	English