Datalogic PowerScan 7000 2D - Intermessage Delay

Data Editing
4-8 PowerScan
®
7000 2D
Intermessage Delay
An intermessage delay of up to 495 milliseconds may be placed between
each scan transmission. Scan the Intermessage Delay bar code below,
then scan the number of milliseconds and the SAVE bar code using the
Programming Chart on page B-5 of this manual.
To remove this delay, scan the Intermessage Delay bar code, then set the
number of steps to 0. Scan the SAVE bar code using the
Programming
Chart on page B-5
of this manual.
2nd Scan Transmission1st Scan Transmission
Intermessage Delay
Intermessage Delay