EasyManua.ls Logo

Datalogic PowerScan 7000 2D - Illumination Lights; Imager Time-Out

Datalogic PowerScan 7000 2D
205 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Illumination Lights
Product Reference Guide 3-11
Illumination Lights
If you want the illumination lights on while reading a bar code, scan the
Lights On bar code, below. However, if you want to turn just the lights
off, scan the Lights Off bar code.
Imager Time-Out
Imager Time-Out powers down the imager after the unit has been idle
for the specified time. To prevent the imager from powering down, set
this time-out to 0. Scan the bar code below, then set the time-out by
scanning digits (from 0 - 999,999 ms) from the
Programming Chart on
page B-5
, then scanning Save. Default = 120,000 ms.
NOTE
This setting does not affect the aimer light. The
aiming light can be set using Aimer Mode (see
Aimer Modes on page 3-13).
Lights Off
* Lights On
Imager Time-Out

Table of Contents

Other manuals for Datalogic PowerScan 7000 2D

Related product manuals