Datalogic PowerScan 7000 2D - Good Read Delay; User-Specified Good Read Delay; Trigger Modes; ManualSerial Trigger

Output
3-4 PowerScan
®
7000 2D
Good Read Delay
This sets the minimum amount of time before the imager can read
another bar code. Default = No Delay.
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar
code below, then set the delay (from 0-30,000 milliseconds) by scanning
digits from the
Programming Chart on page B-5, then scanning Save.
Trigger Modes
Manual/Serial Trigger
You can activate the imager either by pressing the trigger, or using a serial
trigger command (see
Trigger Commands on page 10-5). When in man-
ual trigger mode, the imager scans until a bar code is read, or until the
trigger is released.
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay