Datalogic PowerScan 7000 2D - Alternate Data Formats

Data Formatting
5-6 PowerScan
®
7000 2D
Alternate Data Formats
Alternate formats allow you “single shot” capability to scan one bar code
using a different data format than your primary format. When data for-
mats are programmed (see
page 5-2), you must input whether you are
programming the primary format, or an alternate format numbered 1, 2,
or 3.
An alternate format is initiated by scanning one of the 3 alternate format
bar codes below. The imager will scan the next bar code, formatting the
data with the selected alternate format, then revert immediately to the
primary format.
Alternate Data Format 1
Alternate Data Format 3
Alternate Data Format 2