EasyManua.ls Logo

Datalogic PowerScan 7000 2D - Menu Command Syntax; Query Commands

Datalogic PowerScan 7000 2D
205 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Serial Programming Commands
10-2 PowerScan
®
7000 2D
Menu Command Syntax
Menu commands have the following syntax (spaces have been used for
clarity only):
Prefix Tag SubTag {Data} [, SubTag {Data}] [; Tag SubTag {Data}] […]
Storage
PrefixThree ASCII characters:
SYN M CR (ASCII 22,77,13).
Tag A 3 character case-insensitive field that identifies the desired menu
command group. For example, all RS-232 configuration settings
are identified with a Tag of 232.
SubTagA 3 character case-insensitive field that identifies the desired
menu command within the tag group. For example, the SubTag
for the RS-232 baud rate is BAD.
DataThe new value for a menu setting, identified by the Tag and Sub-
Tag.
StorageA single character that specifies the storage table to which the
command is applied. An exclamation point (!) performs the com-
mand’s operation on the device’s volatile menu configuration table.
A period (.) performs the command’s operation on the devices non-
volatile menu configuration table. Use the non-volatile table only
for semi-permanent changes you want saved through a power cycle.
Query Commands
Several special characters can be used to query the device about its set-
tings.
^ What is the default value for the setting(s).
? What is the devices current value for the setting(s).
* What is the range of possible values for the setting(s). (The devices
response uses a dash (-) to indicate a continuous range of values. A
pipe (|) separates items in a list of non-continuous values.)

Table of Contents

Other manuals for Datalogic PowerScan 7000 2D

Related product manuals