Datalogic QuickScan QD2590

ENTER/EXIT PROGRAMMING MODE 1D SYMBOLOGIES
142 QUICKSCAN™ QD2590
I 2 of 5 Set Length 2
This feature specifies one of the bar code lengths for "I 2 of 5 Length Control" on page
141
. Length 2 is the maximum label length if in Variable Length Mode, or the second
fixed length if in Fixed Length Mode. The length includes the bar code’s check and data
characters. The length can be set from 2 to 50 characters in increments of two. A setting
of 00 specifies to ignore this length (only one fixed length). See "
Set Length 2" on page
250 for more detailed programming instructions.
Select I 2 of 5 Set Length 2 Setting
$CI2L2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

Length 2 = 50 (50 characters)