ENTER/EXIT PROGRAMMING MODE READING PARAMETERS
80
QUICKSCAN™ QD2590
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the
state is entered. The range for this setting is from 1 to 255 seconds in 1-second incre-
ments. See
page 244 in “References” for further description of this feature.
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode. The select-
able range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond incre-
ments. See
page 246 in “References” for detailed information on setting this feature.
$CSNET03
Scanning Active Time = 3 seconds
Scanning Active Time = 5 seconds
$CSNET05
$CSNET08
Scanning Active Time = 8 seconds
Select Flash ON Time Setting
$CSNFN
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
10 = Flash is ON for 1 Second
To Next Page
Loading...
Need help?
General
Weight and Dimensions
