258
QUICKSCAN™ QD2590
APPENDIX B
STANDARD DEFAULTS
The most common configuration settings are listed in the “Default” column of the table
below. Page references are also provided for feature descriptions and programming bar
codes for each parameter. A column has also been provided for recording of your pre-
ferred default settings for these same configurable features.
Table 26 Standard Defaults
PARAMETERS DEFAULT
YOUR SETTING PAGE NUMBER
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore Obey 20
USB Suspend Mode Enable 20
RS-232 ONLY
Baud Rate 9600 22
Data Bits 8 Data Bits 23
Stop Bits 1 Stop Bit 23
Parity None 24
Handshaking Control RTS 25
RS-232/USB-COM
Intercharacter Delay No Delay 27
Beep On ASCII BEL Disable 28
Beep On Not on File Enable 28
ACK NAK Options Disable 29
ACK Character ‘ACK’ 30
NAK Character ‘NAK’ 30
ACK NAK Timeout Value 200 msec 31
ACK NAK Retry Count 3 Retries 30
ACK NAK Error Handling Ignore Errors Detected 32
To Next Page
Loading...
