Datalogic QuickScan QS6500

LED and Beeper Indicators
Product Reference Guide 3-7
Good Read: When to Indicate
This feature specifies when the imager will provide indication (beep and/
or flash its green LED) upon successfully reading a bar code. Choices are:
• Good Read = Indicate after decode
• Good Read = Indicate after transmit
• Good Read = Indicate after CTS goes inactive, then active
NOTE
This option, which uses CTS, is only valid for RS-232
interfaces.
START
INDICATE BARCODE
After decode
After transmit
After CTS goes
inactive, then
active
END