Datalogic QuickScan QS6500

Product Reference Guide i
Table of Contents
Chapter 1 Getting Started .........................................................1-1
About This Manual ............................................................................ 1-1
Manual Conventions .................................................................... 1-2
Default Information ............................................................... 1-2
Nomenclature .................................................................................. 1-2
Symbologies .................................................................................... 1-3
Linear Imager Settings ...................................................................... 1-3
Return to Factory Defaults ................................................................. 1-3
Chapter 2 Bluetooth Models......................................................2-1
Linking an Imager with a Base Station ................................................. 2-1
Unlinking ......................................................................................... 2-2
Battery Charging .............................................................................. 2-3
Paging the Imager ............................................................................ 2-3
Chapter 3 General Features ......................................................3-1
Double Read Timeout ........................................................................ 3-1
Imager Timeout ............................................................................... 3-3
Read Verification .............................................................................. 3-4
LED and Beeper Indicators ................................................................. 3-6
Power On Alert ........................................................................... 3-6
LED Idle State ............................................................................ 3-6
Good Read: When to Indicate ....................................................... 3-7
Good Read Beep Control .............................................................. 3-8
Good Read Beep Frequency ......................................................... 3-8
Good Read Beep Length .............................................................. 3-9
Good Read Beep Volume ........................................................... 3-11
Scanning/Imaging Features ............................................................. 3-12
Scan Mode .............................................................................. 3-12
Stand Mode LED ....................................................................... 3-14
Scan Illumination LED Timeout ................................................... 3-14
Inverted Image Scan ................................................................ 3-15
Global Features .............................................................................. 3-16
Global Minimum Code Length ..................................................... 3-16
Global Maximum Code Length ............................................... 3-17
Chapter 4 Interface Related Features .......................................4-1
Interface Selection ............................................................................ 4-4
Interface Features ............................................................................ 4-8
Global Interface Features ............................................................ 4-8
RS-232 Interface Features ........................................................... 4-9
Hardware Flow Control......................................................... 4-11
Intercharacter Delay............................................................ 4-11
Software Flow Control.......................................................... 4-11