General Features
3-14 QuickScan
®
QS6500/QS6500BT
Stand Mode LED
When this feature is set to ON while in stand mode, the illumination
LEDs go to a dim state after a timeout of reading no labels. When set to
OFF in stand mode, the illumination LEDs go off after a timeout of
reading no labels. In both cases, the illumination LEDs come back on
when something passes in front of the imager.
Scan Illumination LED Timeout
Limits the time following pressing the trigger that the illumination LED
(aiming light) is lit. Disabling this feature turns the illumination off.
Selecting “Continue” means the imager always keeps reading regardless
of whether the trigger button is pressed or the standby duration has
elapsed.
START
STATE BARCODE
LED OFF
LED ON
END
START
DURATION BARCODE
Disable
30 Seconds
60 Seconds
To Next Page
Loading...
