Datasat AP20 - Page 54

AP20 Installation and Operating Guide Page 54
AP20 Installation & Operating Guide Document # 9301H39200 Ver. 1.25
LCD Brightness -Use the on-screen slider or the adjustment knob to adjust the brightness of
your LCD screen.
Using the buttons along the bottom of the System Setup screen, you can update the processor
software via the internet, save and restore configurations through the USB interface, assign
password protections, view a log file of system status messages, and check the status of the
hardware in real time.
Digital Out ClockRate – When interfacing with external digital equipment select appropriate
clock rate to match that equipment. Select from the following options:
 48 kHz
 96 kHz
 192 kHz
Output Mapping – Option to duplicate channels 1-8 on channels 9-16:
 Standard 16 Ch Out – Standard output channel assignments.
 Copy Ch 1-8 to Ch 9-16 – The output of channels 1 through 8 will be copied to output
channels 9 through 16 for both the Analog output connector and Digital output connector.
Output channels 9-16 are not assignable if this option is used.
Fader Control – The Fader knob controls the playback level in the auditorium/theater. It can be
set in either of two modes. (Note: This setting will not affect the main fader display on the Home
screen.)
Two options are available for controlling fader level behavior:
 Global: The fader level setting will affect all audio formats and will not be displayed in the
Home screen. Example: while in a format the fader is adjusted from 5.0 to 6.0; when
another format is selected the fader will remain at 6.0.
 Format: Fader level settings can be assigned to each audio format button on an individual
basis. To differentiate it from the Global setting and allow an easy reference for the
projectionist, the fader level setting for the format will display at the top of the Home
screen below the text “Fmt Fader”. In this mode, if a fader level is adjusted for a specific
format, it will not affect other formats. See next topic.
Note: If the operator needs to preset the level for each audio format, then set up Fader Control
to be in Format mode.