Starting a System with Factory-Installed Software
DEC OSF/1
AXP Initial
Startup Screen
If your system has the DEC OSF/1 AXP operating system
factory-installed, you will see a display similar to the one shown
in Figure 6–5 when you first turn on your workstation or server
and after the system startup messages complete.
Figure 6–5 DEC OSF/1 AXP Initial Startup Display
***********************************************************
* Welcome to the DEC OSF/1 AXP(tm) Factory-Installed *
* Software Startup Procedure. *
***********************************************************
During this startup procedure, you will be prompted to enter
the following information:
o a system name
o a new superuser password
o your local time zone
o the date and time
To discontinue this procedure and halt your system,
enter n at the following prompt.
Would you like to continue? (y/n):
DEC OSF/1
AXP Startup
Dialog
The DEC OSF/1 AXP Factory-Installed Software procedure that
runs when you start your system prompts you to answer some
questions and gives you instructions for completing installation
of your DEC OSF/1 AXP operating system.
Starting Up Your System 6–11
To Next Page
Loading...