Connecting the Workstation
Step 10:
System Power
Cord
Connect the system power cord to the system power socket on
the rear of the system unit, as shown in Figure 3–9.
Figure 3–9 Connecting the Power Cord to the System Unit
MLO-008601
ISDN
S3
2
1
0
Yellow Label
on Power
Connector
If there is a label similar to the one shown in Figure 3–10
covering the system power socket on the rear of the system unit,
your system already has either the OpenVMS AXP or the DEC
OSF/1 AXP operating system factory-installed on an internal
fixed disk drive.
Installing a Workstation System 3–15
To Next Page
Loading...