DEC 600s - Factory-Installed Software Label

Connecting the Workstation
Figure 3–10 Factory-Installed Software Label
Software is preinstalled on the hard disk. See
installation guide before booting system.
Logiciels preinstalles sur le disque dur. Consultez le
guide d’utilisation avant de demarrer le systeme.
Software ist bereits auf def Festplatte installiert. Vor
dem Systemstart installationsanleitung lesen.
Software gia installato sul disco fisso. Consultare il
manuale di installazione prima di avviare il sistema.
El software esta preinstalado en el disco duro. Vease
la guia de instalacion antes de arrancar el sistema.
36-28979-01.D01
Attention:
Attention:
Achtung:
Attenzione:
Atencion:
MLO-007596
Step 11: Power
Outlet
Make sure that the power On/Off switch is in the off (O) position.
Connect the other end of the power cord into a power outlet of
the correct voltage.
Step 12:
Modem
Consult the documentation that came with the modem to unpack
it and clear the Force DSR attribute. (With this attribute
cleared, your system will recognize the loss of the modem
connection, should it occur.) Connect the modem cable to the
synchronous/asynchronous port on the system unit shown in
Figure 3–11.
The modem converts computer signals to signals that can be sent
over a telephone line. It is typically used for communications
in large networks, such as wide area networks (WANs). See
your Digital sales representative for a list of the recommended
modems for your system.
3–16 Installing a Workstation System