DEC 600s - Connecting the Thinwire Cables and T-Connector to the DECXM Transceiver

Connecting to a 10BASE2 (ThinWire) Ethernet Network
Step 4:
ThinWire
Cables and
T-Connector
Connect the ThinWire network cables to the T-Connector and
then the T-connector to the DECXM transceiver as shown in
Figure 5–4.
Figure 5–4 Connecting the ThinWire Cables and T-Connector
to the DECXM Transceiver
MLO-011209
Step 5:
Terminate
Connection
If your workstation is the last one on a 10BASE2 (ThinWire)
network, you need to terminate the network connection. Do this
by connecting a terminator, rather than a ThinWire network
cable, to one side of the T-connector connected to the DECXM
Transceiver as shown in Figure 5–5.
5–10 Connecting Your System to a Network