DEC 600s - Initializing Your System

Running Diagnostic Tests
Initializing Your
System
After you have run a test, you should use the following command
to initialize your system to clear the error log from the system
register. Figure 14–3 shows an example of the init command.
Figure 14–3 Initializing Your System
>>> init
Return
INIT-S-CPU...
INIT-S-RESET_TC...
INIT-S-ASIC...
INIT-S-MEM...
INIT-S-NVR...
INIT-S-SCC...
INIT-S-NI...
INIT-S-SCSI...
INIT-S-ISDN...
>>>
Running Diagnostic Tests 14–9