Connecting the Workstation
Step 5:
Ethernet
Loopback
Connector
Connect the Ethernet loopback connector to the AUI Ethernet
port on the system unit, as shown in Figure 3–4. If you plan to
connect to an AUI Ethernet network or a ThinWire Ethernet
network, you may omit this step. After you have completed
the steps in this chapter, see Chapter 5 for information about
network connections.
Figure 3–4 Connecting the Ethernet Loopback Connector
MLO-008598
ISDN
S3
2
1
0
3–10 Installing a Workstation System
To Next Page
Loading...