DEC 600s - Using the Login Command; Entering a Login Command

Using the login Command
Using the login Command
The login
Command
After entering the password, enabling it, and then changing the
secure system jumper on the I/O board, you must use the login
command to access privileged console commands as Table 11–6
describes.
Table 11–6 Entering a Login Command
Enter this command: System responds:
>>> login
Return
PSWD0>
PSWD0>
password
Return
>>>
The variable password is the password you entered during the
set password command. If you enter the password incorrectly,
the system responds with this message:
? 30 ILL PSWD
Enter the login command again as described previously.
Using the Password Security Feature 11–15