Connecting to an AUI Ethernet Network
Connecting to an AUI Ethernet Network
Procedure
Overview
To connect your system to an AUI Ethernet network, sometimes
referred to as thickwire or standard Ethernet, complete the steps
in Table 5–2.
Table 5–2 Steps for Connecting an AUI Ethernet Network
Step Action
1 Remove the loopback connector.
2 Connect the AUI Ethernet cable.
3 Push the sliding connector lock to secure cable.
Step 1:
Loopback
Connector
If the loopback connector is still connected to your system,
remove it now. Keep the loopback connector in a safe place. You
may need it later for testing purposes.
Step 2: AUI
Ethernet Cable
Connect the AUI Ethernet cable (BNE4C-xx) to the AUI port on
the rear of the system unit as shown in Figure 5–1.
5–4 Connecting Your System to a Network
To Next Page
Loading...